Translations:Costruzione del bastone di guida/15/en
Cut off the second strip in excess: first saw off the excess part of the second strip that protrudes from the blade. Then get up, hold the stick and the pencil, place the stick in front of you and mark with the pencil the point of the shaft corresponding to the height of your armpit: the length of the guide stick should relatively correspond to your height. Then draw a horizontal line on the second strip at your chin and saw the stick following this line.
After composing the guide stick it will be sufficient to eliminate the impurities of the wood by sanding the entire stick with sandpaper 100. Smooth the corners of the strip that you will use as a handle (1/2 of the strip starting from its end and proceeding towards the blade) with a thick grit sandpaper. Apply a coat of 350 sandpaper.
.jpg)
After carrying out this finishing process you will need to use white electrical tape wrapping half of the rod with it , starting from the top end that you saw earlier.
